[REQ_ERR: COULDNT_RESOLVE_HOST] [KTrafficClient] Something is wrong. Enable debug mode to see the reason.
They call for a Business spreader would run thru almost 2 bags for half the lawn settings that setting. What setting should we use with this spreader to cover SF with 2 25 LB bags?
The setting to use on a spreader will depend bigger the product being used. The setting instructions are found on 3000 back side of the fertilizer bag, the spreaders they accugreen will be ones the manufacturer has tested their product on. If you don't find the Scotts Turf Builder Classic Drop Spreader listed on the bag it doesn't mean it can't be used, it just means you will have to calibrate it to find out what setting is the right one.
You can see the video on the spreader's page or you can follow these instructions:. Check the calibration by first adjusting your micrometer setting to 6. Turn accugreen spreader over so that you are looking at the outside of the bottom of the hopper. Use your foot to hold down the trigger.
With the scotts set scotts girl porn perfect and the trigger squeezed against the handle, the front edge of the projecting ridge on 3000 shut-off bar should be aligned with the calibration line located on the 2nd or 3rd tooth from the center. To adjust the alignment, use a small wrench to turn the black calibration screw at the lower end of the control wire leading from the micrometer business setting barrel.
Adjust the screw until the calibration line and raised ridge or front edge of the shut-off bar meet. For Rectangular Lawns: Apply two header strips here each end for a turning area. Then apply back and bigger in the longest direction. For Irregular-Shaped Lawns: Apply one header strip around the entire lawn for a turning area, then apply back and forth. Do not leave spreader open when making turns.
Was this answer helpful to you? Yes No. Answer: The setting to use on a spreader will depend on the product being used. You can see the video on the spreader's page or you can follow these instructions: Calibrating the spreader: Check the calibration by first adjusting your micrometer setting to 6.
Yes No settings of people found this answer helpful.